1. Fold the seatbacks down. See Rear
Seats (page 130).
2. If the retention net is folded, press the
red release button C on the hinges of
the upper and lower bar 1 and unfold
it.
3. Push the ends of the upper bar towards
each other and insert them into the
retainers on the roof A or B. Make sure
that the flap for the center safety belt
is situated on the right hand side of the
vehicle.
4. Push the bar forwards into the narrow
section of the retainers 2.
5. Attach the net to the luggage anchor
points 3. See Luggage Anchor Points
(page 195).
6. Tighten the belts 4.
Remove in the reverse order.
If you need to use the center safety belt:
1. Open the flap 5.
2. Route the safety belt through the
opening.
Luggage retention net - type 2
CAUTIONS
Do not exceed the maximum
permissible retention net load of 1
kilogram (2 pounds).
Do not place large objects in the lower
net storage compartments.
Make sure that the rods are securely
positioned in the trim panels.
1. Fold the third row seats flat. See Rear
Seats (page 130).
2. Insert one end of each rod into the
retainers in the luggage compartment
trim panel.
3. Push the other end of each rod toward
its center and insert the rod into the
retainer in the opposite trim panel.
Note: The upper rod ends can be inserted
into either the top or front retainer in the trim
panels.
Note: On S-MAX the lower net incorporates
three storage compartments. Make sure that
the net is positioned so that the storage
compartments face towards the rear.
201
Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing
Load Carrying
To Next Page
Loading...
