If there are several Bluetooth devices in
vehicle, system will try to connect to the
primary phone. If the primary phone is not
available in the vehicle, SYNC® will
connect to the available paired phone after
searching is finished.
Note: In some phones an access
confirmation will pop up in phone's screen,
"YES" needs to be always selected to allow
SYNC to automatically connect and transfer
phonebook.
Changing the active phone
Note: Phones must be paired to the system
before they can be made active.
1. Press PHONE button.
2. Press the up or down arrow buttons
until BT devices is shown and press
OK.
3. Press the up or down arrow buttons
until Connections is shown and press
OK.
4. Press the up or down arrow buttons to
select the desired bluetooth device.
5. Press OK button to connect to the
selected phone.
Downloading phonebook
SYNC® can support downloading up to
approximately 1000 entries per
Bluetooth-enabled mobile phone.
1. Press PHONE button.
2. Press the up or down arrow buttons
until Phone settings is shown and
press OK.
3. Press the up or down arrow buttons
until Phonebook pref. is shown and
press OK.
4. Press the up or down arrow buttons
until Download now is shown and
press OK.
5. Press OK button again to confirm
download.
Phone Voice Commands
Overview
The overview below shows the available
voice commands. The following lists will
give further information about the
complete command menu in selected
examples
Press VOICE BUTTON and when prompted, say any of the following commands
"READ SMS"
"CALL" / "DIAL"
"CALL <name>"
"CALL <name> HOME PHONE"
"CALL <name> PHONE"
"CALL <name> MOBILE PHONE"
"CALL <name> OTHER NUMBER"
12
SYNC
To Next Page
Loading...
