Formlabs Form 2 - Cleaning the tank resin

3D PRINT - FormLab 2 CHAPTER 3. CLEANING
3.2 Cleaning the tank resin
• Inspect the bottom surface of tank.
• Clean the tank with an acrylic cleaner.
• Put a small amount acrylic cleaner into the tank resin.
• Clean with a microfiber black paper.
• Remove the dust from the ID chip with a rubber bulb air blower.
• Inspect inside the tank 1 .
• Check with a spatula all resin surface by beginning from the top-right to the
bottom- left side 2 .
16