Formlabs Fuse 1 - Page 11

Introduction | 9
Parameter Unit
3D printing technology Selective Laser Sintering (SLS)
Minimum dimensions for convenient
access (W × D × H)
125.5 × 149.5 × 187.0 cm | 49.4 × 59.0 × 73.6 in
Printer dimensions (W × D × H) 64.5 × 68.5 × 107 cm (165.5 cm with stand)
25.4 × 27.0 × 42.0 in (65.0 in with stand)
Printer weight 114 kg (without build chamber or powder)
251.3 lb (without build chamber or powder)
Build chamber dimensions (W × D × H) 27.9 × 34.2 × 48.9 cm | 11.0 × 13.5 × 19.3 in
Build chamber weight 11 kg (17.6 kg, full with 20% packed powder)
24.3 lb (38.8 lb, full with 20% packed powder)
Build volume (W × D × H) 16.5 × 16.5 × 30.0 cm | 6.5 × 6.5 × 11.8 in
Material refresh rate Print with up to 70% recycled powder
Startup time 60 minutes
Build speed 10 mm/hour | 0.39 in/hour
Hopper capacity 9 kg powder | 19.8 lb powder
Operating environment 20–27 ºC | 68–81 ºF
Operating temperature 200 ºC | 392 ºF
Temperature control Quartz tube heating elements
Positive temperature coecient (PTC) cartridges
Air handling Pressure-controlled two-stage filtration (Replaceable HEPA
and carbon mediums)
Power requirements EU: 230 VAC, 7.5 A (dedicated circuit)
US: 120 VAC, 15 A (dedicated circuit)
Laser specifications EN 60825-1: 2014
Class 1 laser product
1065 nm
Maximum 10 W
4.01 mrad beam divergence (nominal, full angle)
Laser spot size (FWHM) 200 μm | 0.0079 in
Radiation information The Fuse 1 is a Class 1 laser product. Accessible radiation is
within Class 1 limits.
Connectivity Wi-Fi: 2.4 GHz
Ethernet: 1000 Mbit
USB: 2.0
Wi-Fi connectivity Protocol: IEEE 802.11 b/g/n
Frequency: 2.4 GHz
Supported security: WPA/WPA2
Ethernet connectivity RJ-45 Ethernet (10BASE-T/100BASE-TX/1000BASE-T) LAN port
Connect with a shielded Ethernet cable (not included):
minimum Cat5, or Cat5e or Cat6 for 1000BASE-T.
USB connectivity USB (rev 2.0) B port with a USB A-B cable
Printer control Interactive touchscreen
Powder dispensing system Automated
Alerts Touchscreen alerts, SMS/email via Dashboard
Print preparation PreForm desktop software
File type STL or OBJ