Formlabs Fuse 1 - Maintenance; 6.1 Tools and Supplies

Maintenance | 39
6 Maintenance
To maintain the most ecient and long-lasting machine, ensure regular conservation. Formlabs
provides instructions to advise in installing, operating, and maintaining the machine. It shall
only be maintained by a qualified and trained person. Unauthorized disassembly or repair
procedures may damage the machine.
There are two groups of maintenance procedures: regular, which should be done after every
print, and intermittent maintenance, which only needs to be done occasionally. Please keep
a log detailing when each intermittent maintenance procedure was last performed. Prior to
starting a print, the machine displays prompts on its touchscreen to notify the operator if any
intermittent procedures are past due.
Tampering with, or disassembling the Fuse 1 prior to disconnecting the power cable
and waiting approximately ten minutes can subject users to potentially fatal electrical
hazards.
Wear personal protective equipment (PPE) when performing maintenance tasks. Use
tools only as described.
When removing the exterior paneling, disconnect the machine from its power source
before maintenance. Moving parts present crushing and tangling hazards.
• Formlabs provides instructions to advise skilled and unskilled persons in installing,
operating, and maintaining the Fuse 1. The Fuse 1 shall only be maintained by a
qualified and trained person.
• Do not open the Fuse 1 and/or investigate internal components unless under the
guidance of Formlabs Support or a certified service provider. Contact Formlabs
Support or a certified service provider for any additional guidance.
• Unauthorized disassembly or repair procedures may damage the machine and void
the warranty.
6.1 Tools and supplies
Only use tools, chemicals, or procedures to maintain the Fuse 1 that are outlined in this manual,
by prompts on the touchscreen, and on support.formlabs.com.
Do not use any tools, chemicals, or unapproved procedures with the Fuse 1 unless otherwise
instructed to do so by Formlabs or a certified service provider.
The cleaning tools used to maintain the Fuse 1 are consumables, and intended for
single-use only. Do not reuse a cleaning tool from one component with another.
DANGER
WARNING
CAUTION
NOTICE
NOTICE