1 Table of Contents
1 Preface ..................................................................6
1.1 Read and retain instructions ................................................6
1.2 Obtaining documentation and information ...................................6
2 Introduction ..............................................................8
2.1 Intended use ..............................................................8
2.2 Technical specifications ....................................................8
2.3 Product components. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
2.4 Fuse 1 user interface ......................................................13
3 Safety ...................................................................14
3.1 Component and subsystem safety .........................................15
3.2 Personal protective equipment (PPE) .......................................18
3.3 Specification of tools to be used ...........................................18
3.4 Sensitive components ....................................................19
3.5 Emergency and exceptional situations ......................................19
4 Preparation and setup ....................................................21
4.1 Location and environs ....................................................21
4.2 Power and networking ................................................... 22
4.3 Unboxing the machine ................................................... 22
4.4 Accessing the serial name. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
4.5 Installing the machine .................................................... 24
4.6 Setting up a network connection .......................................... 25
4.7 Updating firmware ....................................................... 26
4.8 Registering powder credit ................................................ 26
4.9 Preparing the optical cleaning kit. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28
4.10 Transporting the machine ................................................ 29
5 Printing ................................................................ 32
5.1 Operational environment ................................................. 32
5.2 Designing for SLS ....................................................... 32
5.3 Setting up a print .........................................................33
5.4 Preparing for a print ......................................................34
5.5 Retrieving and cleaning prints with the Fuse Sift .............................37
5.6 Managing the machine ................................................... 38
To Next Page
Loading...
