Formlabs Fuse 1 - Disassembly and Repair; 8.1 Tasks

54
8 Disassembly and repair
All steps that involve opening the machine and/or investigating internal components should be
done by skilled persons under the guidance of Formlabs Support or a certified service provider.
Any damage resulting from attempting disassembly and/or repair without prior authorization
from Formlabs Support or a certified service provider is not covered by warranty.
8.1 Tasks
Contact Formlabs Support or a certified service provider to receive repair instructions and
authorization, including how to disassemble or remove the exterior paneling.
Task Frequency
Replacing the build chamber piston seal When advised by Formlabs Support or a certified
service provider
Replacing the print enclosure door seal When advised by Formlabs Support or a certified
service provider
Replacing the laser fan mesh When advised by Formlabs Support or a certified
service provider
Replacing the quartz heaters When advised by Formlabs Support or a certified
service provider
Replacing the IR sensor When advised by Formlabs Support or a certified
service provider
Any other maintenance or repair tasks not listed in section 6 Maintenance requires servicing
the machine. Contact Formlabs Support or a certified service provider to request in-field
service or an RMA (short for “return to manufacturer authorization”).