NT8 User's Guide | Chapter 8: Software Overview
TIP CADDY STATIONS
In order for the NT8 to pick up tips from the tip caddy on the machine, you must configure
the tip caddies in the software.
Setting Up the Low Volume Tip Caddy
1. Drag and drop the LV Tip Caddy container to the LV tip caddy station (skip this step
if the LV Tip Caddy container is already there).
2. Right-click on the LV tip caddy station and select Configure LV Tip Caddy. The Tip
Caddy Setup dialog box appears.
3. Click the Set Full button if you want to set the entire tip caddy. To set individual tips,
click the desired tip (represented by the four circles inside the box).
4. Click OK.
Other right-click menu options:
Setting Up the High Volume Tip Caddy (Plate Copy Option Only)
1. Drag and drop the HV Tip Caddy container into the HV tip caddy station (skip this
step if the HV Tip Caddy container is already there).
2. Right-click on the HV tip caddy station and select Configure HV Tip Caddy. The Tip
Caddy Setup dialog box appears.
Area Description Information
Add Adds the command(s) to the Task List and closes the Task
Details dialog.
Add More Adds the command(s) to the Task List and waits for you to
define the next task.
Close Exits the Task Details dialog.
Item Description
Pick Tip Adds the Pick Tip command to the task list. You can also add
a pick tip command to a specific index location by right-
clicking on the desired tip index and selecting Pick Tip.
New Tip Caddy Creates a new LV tip caddy.
Detach LV Tip Caddy Detaches the LV tip caddy.
To Next Page
Loading...