Configuration
Configuration
You can configure the 3G/4G LTE modem in your FortiGate 30E in either of the following ways:
l Configure the modem from FortiGate GUI on page 17
l Configure the modem from FortiGate Console on page 18
Many new features and functions have been added to the Console, but may not have been
implemented in the GUI yet. For this reason, we highly recommend configuring the
LTEmodem via the FortiGate Console.
Configure the modem from FortiGate GUI
Follow these instructions to configure the device from the GUI:
1.
Set the Ethernet port on your computer to DHCP mode.
2.
Use an Ethernet cable to connect your computer to your FortiGate 30E via any of the Ethernet ports (1 through 4).
3.
Start your browser and enter the address of your FortiGate 30E.
4.
On the log-in page, enter the default username ‘admin’ (case-sensitive) in the Username field, leave the Password
field blank (no password), and press Login.
Note: By default, the FortiGate 30E GUI opens to the Dashboard>Status page after you log in.
5. Check the status of the modem interface by selecting Network>Interfaces, as shown in the following illustration.
FortiGate-FortiWiFi 5.0 3G4G LTE Modem Operator's Manual 17
Fortinet Technologies Inc.
To Next Page
Loading...