diagnose sys lte-modem
diagnose sys lte-modem data-session-info
LTE Modem data session information:
Interface name: wwan
Connection status: QMI_WDS_CONNECTION_STATUS_CONNECTED
Profile ID: 1
Data profile name:
Profile type: QMI_WDS_PROFILE_TYPE_3GPP
PDP context type: QMI_WDS_PDP_TYPE_IPV4
APN name: broadband
IP family: QMI_WDS_IP_FAMILY_IPV4
IP: 10.53.79.115
IP gateway: 10.53.79.116
IP netmask: 255.255.255.248
Primary DNS: 172.26.38.1
Secondary DNS: 0.0.0.0
MTU: 1430
Auto connect: QMI_WDS_AUTOCONNECT_DISABLED
Network type: Unknown WDS Bearer Tech
Network type(last): Unknown WDS Bearer Tech
Link protocol: QMI_WDA_LINK_LAYER_PROTOCOL_RAW_IP
This command enables you to see the information of the current LTE modem data session. The following table
highlights the key parameters in data session information.
Parameter Description
Interface name The name of the LTE network interface
Connection status The status of the connection
Profile ID The wireless profile used in the current data session
Profile type The type of wireless profile used in the data session
PDP context type The PDP types allowed by the wireless profile
APN name The name of the carrier's APN
IP family The IP family used in the data connection. It can be either IPv4 or IPv6.
Note: IPv6 session is not supported for the current release.
IP
Note: IP addresses are always acquired through DHCP although some SIM cards
offer static IPs.
MTU The MTU on the wireless front end.
Note: The MTUon the Ethernet interface wwan can be different. If the wwan
runs the link protocol RAW IP, the MTU on the Ethernet interface must be
changed to the same as the one on the wireless front end. Otherwise, it will not
work.
FortiGate-FortiWiFi 5.0 3G4G LTE Modem Operator's Manual 34
Fortinet Technologies Inc.
To Next Page
Loading...