Fortinet FortiGate-FortiWiFi - MIB Browsing and Data Access

MIBs
To verify if SNMPis enabled on the WAN interface of the FortiGate device:
1. Click Network>Interfaces.
2.
Under Physical (2), in the Access column, make sure SNMPis there, as illustrated in the following image.
If for some reason SNMPis not enabled on the wan interface, you can enable it using the following procedures.
1.
Double-click the wan interface (refer to the image above) to open its configuration page.
2.
Under the Administrative Access, select SNMP, as illustrated below.
3. Click OK.
Configure a MIBbrowser
You need a MIB browser to pull data from SNMP agents such as routers, switches, and servers (FortiGate in this case).
In addition, a MIB browser also enables you to retrieve and display MIB data in a human-readable form.
The following example shows the configuration and use of the iReasoning MIBbrowser.
Make sure that the information you enter in the MIB browser matches that on the
SNMPagent (FortiGate). Fro more information, see Configure a MIBbrowser on page 53.
FortiGate-FortiWiFi 5.0 3G4G LTE Modem Operator's Manual 53
Fortinet Technologies Inc.