Diagnostic test commands
Internal debugging commands
The diag test app lted 9 and diag test app lted 10 commands are used for internal debugging. The
diag test app lted 11 command returns all AT commands.
FortiGateRugged-60F-3G4G # dia test app lted 9
admin status: 1
has_usb_lte_dev: 1
monitor_enabled: 1
link/connection status: 0
Interface up/down status: 1
dump_it_cmd: 1
exit_lted: 0
dev type: 1
connect_failed: 0
rssi: 0
last modem offline time jiffies: 0
scheduled hot swap jiffies: 0
current jiffies: 7884153
FortiGateRugged-60F-3G4G # dia test app lted 10
resync status: has_usb_lte_dev:1, admin:1, monitor:1
Get modem ID
The diag test app lted 12 command returns the modem ID.
FortiGateRugged-60F-3G4G # dia test app lted 12
ESN=0, IMEI=353533100636565, MEID=
Get ICCID
The diag test app lted 13 command returns the ICCID.
FortiWiFi-40F-3G4G # dia test app lted 13
89014103271134616653
Get firmware preference
The diag test app lted 14 command returns the firmware preference from the modem. By checking this
information, you can make sure that the firmware is running the firmware of your choice.
FortiWiFi-40F-3G4G # dia test app lted 14
Image information from the modem:
Modem image count ==> 2
Image type ==> 0
Modem firmware version ==> 00.00.00.00
FortiGate-FortiWiFi 5.0 3G4G LTE Modem Operator's Manual 45
Fortinet Technologies Inc.
To Next Page
Loading...