EasyManua.ls Logo

Fortinet FortiGate-FortiWiFi - Set Allow-Modify-Wireless-Profile-Table; Set Sim-Hot-Swap; Set Connection-Hot-Swap

Fortinet FortiGate-FortiWiFi
69 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuration
set allow-modify-wireless-profile-table
allow-modify-wireless-profile-table Allow LTE daemon to modify wireless profile table, if
running GENERIC firmware.
FortiWiFi-40F-3G4G (lte-modem) # set allow-modify-wireless-profile-table
enable Allow LTE daemon to modify wireless profile table.
disable Do not allow LTE daemon to modify wireless profile table.
For the "generic" firmware, there are no wireless table entries stored in the modem. This option basically tells the
daemon to auto-create a matching wireless profile entry according to the APN setting if the current firmware is set to
generic, which is the default value of this setting.
set sim-hot-swap
FortiWiFi-40F-3G4G (lte-modem) # set sim-hot-swap
enable Enable SIM card auto detection.
disable Disable SIM card auto detection
For Soc4 LTE platforms such as FGT/FWF 4XF-3G4G units with two physical SIM slots, this configuration is for
enabling FortiOS to automatically switch to the slot with an inserted SIM card. If it is enabled, the first inserted SIM card
will be used regardless of which slot the card is inserted. If disabled, a SIM card must be inserted to the slot which
FortiOS is currently using.
set connection-hot-swap
FortiGateRugged-60F-3G4G (lte-modem) # set connection-hot-swap
5-minutes Perform SIM card hot swapping if current card is not able to connect for 5
minutes.
10-minutes Perform SIM card hot swapping if current card is not able to connect for 10
minutes.
never SIM card hot swap based on card presence only.
If enabled, FortiOS will chooses the SIM card to be used according to its connectivity rather than mere presence. If no
SIM card is connectable, FortiOS will continue scanning both slots until a valid SIM card is in place.
This option is available only when “sim-hot-swap” is enabled. Otherwise, it is hidden.
A bug related to this option will render the unit unable to establish an LTE connection in
FortiOS6.2.4 , 6.2.5 and 6.4.2. This issue will be fixed in later FOS releases. A temporary
workaround is to disable this option.
FortiGate-FortiWiFi 5.0 3G4G LTE Modem Operator's Manual 28
Fortinet Technologies Inc.

Table of Contents