Diagnostic test commands
FortiWiFi-40F-3G4G # dia test app lted 2
Data connection status: QMI_WDS_CONNECTION_STATUS_CONNECTED
Connect and disconnect the modem
The diag test app lted 3 and diag test app lted 4 commands let you activate or deactivate the
modem.
FortiWiFi-40F-3G4G # dia test app lted 3
Modem activation succeeded!
FortiWiFi-40F-3G4G # dia test app lted 4
Modem deactivation done.
If the connection activation fails, the cause of the failure will be decoded and displayed
onscreen.
Show signal strength
The diag test app lted 5 command shows the signal strength of the modem, depending on whether
LTEservice is available or not.
The following shows the screen output when LTEservice is available.
FortiWiFi-40F-3G4G # dia test app lted 5
at!gstatus?
!GSTATUS:
Current Time: 82609 Temperature: 42
Reset Counter: 3 Mode: ONLINE
System mode: LTE PS state: Attached
LTE band: B2 LTE bw: 20 MHz
LTE Rx chan: 800 LTE Tx chan: 18800
LTE SSC1 state:INACTIVE LTE SSC1 band: B12
LTE SSC1 bw : Unknown LTE SSC1 chan: 5110
LTE SSC2 state:INACTIVE LTE SSC2 band: B30
LTE SSC2 bw : Unknown LTE SSC2 chan: 9820
LTE SSC3 state:NOT ASSIGNED
LTE SSC4 state:NOT ASSIGNED
EMM state: Registered Normal Service
RRC state: RRC Connected
IMS reg state: No Srv
PCC RxM RSSI: -61 PCC RxM RSRP: -96
PCC RxD RSSI: -55 PCC RxD RSRP: -86
SCC1 RxM RSSI: -72 SCC1 RxM RSRP: -94
SCC1 RxD RSSI: -66 SCC1 RxD RSRP: -86
SCC2 RxM RSSI: -87 SCC2 RxM RSRP: -110
SCC2 RxD RSSI: -86 SCC2 RxD RSRP: -113
Tx Power: -- TAC: 8b3f (35647)
RSRQ (dB): -14.1 Cell ID: 0a38ed09 (171502857)
FortiGate-FortiWiFi 5.0 3G4G LTE Modem Operator's Manual 43
Fortinet Technologies Inc.
To Next Page
Loading...