Configuration
FortiWiFi-40F-3G4G (lte-modem) # set authtype both
FortiWiFi-40F-3G4G (lte-modem) # set
status Enable/disable USB LTE/WIMAX device.
extra-init Extra initialization string for USB LTE/WIMAX devices.
manual-handover Enable/disable manual handover from 3G to LTE network.
force-wireless-profile Force to use wireless profile index (1 - 16), 0 if
don't force.
authtype Authentication type for PDP-IP packet data calls.
username Authentication username for PDP-IP packet data calls.
passwd Authentication password for PDP-IP packet data calls.
apn Login APN string for PDP-IP packet data calls.
modem-port Modem port index (0 - 20).
network-type Wireless network type.
auto-connect Enable/disable modem auto connect.
gps-service Enable/disable GPS daemon.
data-usage-tracking Enable/disable data usage tracking.
gps-port Modem GPS port index (0 - 20).
band-restrictions Bitmaps for the allowed 3G and LTE bands.Ex:
0000000000000000-0000000000001008 (3G Mask-LTE Mask)
image-preference Modem image preference.
allow-modify-wireless-profile-table Allow LTE daemon to modify wireless profile table, if
running GENERIC firmware.
sim-auto-switch Enable/disable SIM card auto detection.
connection-auto-switch Enable/disable SIM card switch based on connectivity.
set network-type
FortiWiFi-40F-3G4G (lte-modem) # set network-type
auto Automatic detection
umts-3g UMTS 3G -- For networks use GSM technology
lte LTE
cdma-hrpd CDMA and HRPD -- For networks use CDMA technology
By default, network-type is set to auto mode. This allows the modem to automatically connect to the LTE network when
it's available, or fall back to the 3G mode when LTE signal is lost. The modem is designed to hand over back to the LTE
network when the signal comes back.
You can also force the modem to 3G- or LTE-only mode by using the other three commands.
Keep in mind that you must not specify umts-3g on a modem with the CDMA network
firmware or cdma-hrpd on a modem with the GSM network firmware.
set modem-port
FortiWiFi-40F-3G4G (lte-modem) # set modem-port
modem-port Enter an integer value from <0> to <20> (default = <255>).
Almost all modems have a modem port (i.e., the AT Command port). For PPP modems, the modem port is critical
because it is the only port to control the modem and to transfer data. For modems such as the EM-series, although the
modem port is not used to make or close data sessions, it is still used to get status information from the modem. As
discussed earlier, modems expose some USB serial interfaces, and the FortiOS enumerates them as /dev/ttyusbX
FortiGate-FortiWiFi 5.0 3G4G LTE Modem Operator's Manual 24
Fortinet Technologies Inc.
To Next Page
Loading...