Fortinet FortiGate-FortiWiFi - SNMP Configuration

MIBs
3. Click Apply, as illustrated below.
Create SNMPcommunity
1. On the SNMPpage, under the SNMPv1/v2c section, click Create New.
The New SNMPCommunity configuration dialog opens.
2.
Specify the Community Name, e.g., lte.
3. Specify the address of the SNMP hosts, and set Host Type to Accept queries and send traps.
4.
Make the other desired selections.
5. Click OK.
The following illustrations show the configuration of an SNMP community named "lte".
FortiGate-FortiWiFi 5.0 3G4G LTE Modem Operator's Manual 51
Fortinet Technologies Inc.