Fortinet FortiGate-FortiWiFi - Page 19

Configuration
l 9600 baud rate
l Data bits 8
l Parity None
l Stop bits 1
l Flow control None
We highly recommend setting baud rate to 115200 if we want to capture LTE modem
debug information. We also recommend using Telnet or SSH, if possible, to prevent
output overflow.
3. Press Enter on your keyboard to bring up the command line interface (CLI).
4. Type in the default username "admin", but with no password, and press Enter on your Keyboard to log in to the
Console.
5.
Check the network configuration.
6.
Us the following commands to check that the firewall policy allows all traffic from the internal ports to the wwan
interface:
FortiWiFi-40F-3G4G # sh firewall policy
config firewall policy
edit 1
set uuid 92f6165c-e23a-51ea-3694-7a20107fe598
set srcintf "internal"
set dstintf "wan"
set srcaddr "all"
set dstaddr "all"
set action accept
set schedule "always"
set service "ALL"
set nat enable
next
edit 2
set uuid 92f7ac10-e23a-51ea-f648-471c047f588f
set srcintf "guestwifi"
set dstintf "wan"
set srcaddr "all"
set dstaddr "all"
set action accept
set schedule "always"
set service "ALL"
set nat enable
next
FortiGate 30E comes with a default firewall policy that allows all traffic from internal ports
to the wwan interface. Make sure the policy is in place before moving on to the next step.
FortiGate-FortiWiFi 5.0 3G4G LTE Modem Operator's Manual 19
Fortinet Technologies Inc.