5. Installation
14. Optional: Check the wavelength of the sensor with the Measuring Case:
a) Connect the sensor to the Measuring Case. See Connecting a Sensor,
page 33.
b) Check the wavelength of the sensor with the Measuring Case. See
instructions for use of the Measuring Case.
Wavelength after installation see data sheet.
If the wavelength is not within the specified range: The sensor can only be
used with a limited measuring range.
P
Sensor is attached.
26 / 42 4-10_1.3.x_4.0_fos4Strain expert-en-us © fos4X 2019
To Next Page
Loading...