5. Installation
If no adhesive is visible: Not enough adhesive present. Installation failed.
2. Optional: Check the wavelength of the sensor with the Measuring Case:
a) Connect the sensor to the Measuring Case. See Connecting a Sensor,
page 33.
b) Check the wavelength of the sensor with the Measuring Case. See
instructions for use of the Measuring Case.
Wavelength after installation see data sheet.
If the wavelength is not within the specified range: The sensor can only be
used with a limited measuring range.
P
Installation checked.
© fos4X 2019 4-10_1.3.x_4.0_fos4Strain expert-en-us 31 / 42
To Next Page
Loading...
Need help?
General