NVR User Manual
www.foscam.com
Step2 Configure the network parameter.
You can select the network type from the drop-down list box.
If select the DHCP, the NVR system will automatically obtain an IP
address and other network settings from that server.
If select the Static IP, you can configure an IP address and other
The default value is 443.
You can configure the IP address of the NVR system.
Note:
The IP of IP cameras, PC and NVR should be in the same network segment
and in the same LAN.
The subnet mask of the NVR system.
The gateway of the NVR system.
The primary DNS server of the NVR system.
The secondary DNS server of the NVR system.
You can use the UPnP function to enable the fast connection of the device
to the WAN via a router without port mapping.
Note:
If you want to enable the UPnP function of the NVR, you must enable the
UPnP function of the router to which your NVR is connected.
How to configure the IP Address, Subnet Mask, Gateway, Primary DNS Server, Secondary DNS
Server, please refer to 4.2 Common Operations 2. Configure the IP Parameters.
Step3
Click Save button to take effect.
-------End
Email