Foscam IP Camera - Set Motion Detect Config

Foscam IPCamera CGI User Guide
Copyright@ Shenzhen Foscam Intelligent Technology Limited
10
bit2:Snap picture
bit3:Record
snapInterval
The interval time to snap picture again
sensitivity
Motion detect
sensitivity
0 : Low
1: Normal
2: High
3: Lower
4: Lowest
triggerInterval
The time of which motion detect alaram
can trigger again when a motion
detection has happened.
scheduleN
The motion alaram schedule of one week,
N = 0(Monday) ~6(Sunday)
For detail, see *1 bellow
areaN
The area info of row N
For detail, see *2 bellow
Note
·Video region is divided into 10*10 sub areasideo region is divided into 10*10
sub areas
·The min unit of schedule is half an hour
Example
/cgi-bin/CGIProxy.fcgi?cmd=getMotionDetectConfig&usr=admin&pwd=
setMotionDetectConfig
Function
Set motion detect config
privilege
admin
Usage
/cgi-bin/CGIProxy.fcgi?cmd=setMotionDetectConfig
Param
isEnable
Is enable motion detect alarm
linkage
Motion alarm linkage
( bit3 | bit2 | bit1 | bit0 )
bit0:Ring
bit1:Send mail
bit2:Snap picture
bit3:Record
snapInterval
The interval time to snap picture again
sensitivity
Motion detect
sensitivity
0 : Low
1: Normal
2: High
3: Lower
4: Lowest
triggerInterval
The time of which motion detect alaram