• Auto Export: Enable exporting after each sample. This setting allows some
product results to be exported while other products will not be exported. This
setting applies to all instruments using products that link to the operation
profile.
Fig. 58
In Nova Care view, Export tab, there are also options that affect the Auto Export
feature. The Wizard Automate sample transfer can be used to set up both import
and export of sample data.
• Allow automatic export of reports: If the Auto Export format for the
instrument is configured to use a Crystal Report template, then this setting
applies. It is enabled by default and can be used locally on the instrument to
disable auto export using report templates. Note that this setting is also used
when the report template is used to produce a .CSV file.
• Turn off automatic export: Tick the box to turn off automatic export of
results.
• Export paths: It is possible to configure paths for four different kinds of
export.
For convenience, these values settings can also be inspected in FossManager but
cannot be changed in the setting group named Local Nova settings.
Fig. 59
To Next Page
Loading...
Need help?
General
