3
The following symbols, accompanied by the words: “DANGER”, “WARNING”, indicate the potential hazard
resulting from failure to observe the associated warning, as specified below:
Failure to observe this warning may result in electric shock
Failure to observe this warning may cause personal injury
and/or damage to property
Failure to observe this warning may cause damage to the
pump, the unit or the system
- CAUTION:
Make sure the pumps are fully primed before you start them.
- CAUTION:
Ensure the correct direction of rotation of the pumps.
- CAUTION:
The control panel must be connected by a qualified electrician in compliance with the electrical regulations in force.
- CAUTION:
The electric pump or the motor and the panel must be connected to an efficient grounding system in compliance with the
electrical regulations locally in force.
- CAUTION:
Ground the unit before carrying out any other operation.
- CAUTION:
The electric pump or the motor can start up automatically.
- CAUTION:
As a general rule, always disconnect the power supply before proceeding to carry out any operation on the electrical or
mechanical components of the unit or system. If you must work inside the electrical panel is also necessary to disconnect
the internal battery (installed simultaneously with GSM module).
The purpose of this manual is to provide the necessary information for the proper installation, use and maintenance of
FULL-APP 2. The user should read this manual before operating the unit. Improper use may cause damage to the machine
and lead to the forfeiture of the warranty coverage. Always specify the model identification code and the construction
number when requesting technical information or spare parts from our Sales and Service department. The instruction and
warnings given below concern the standard version; refer to the sale contract documentation for modifications and special
version characteristics. For instructions, situations and events not considered in this manual or in the sale documents,
please contact our customer service.
Our units must be installed in sheltered, well-ventilated, non-hazardous environments and must be used at a maximum
temperature of +40°C and minimum of -5°C (relative umidity 50% at 40°C not condensed).
1. WARNINGS
2. OVERVIEW
To Next Page
Loading...
