Fourgroup Full-App 2 - 11. SETTINGS PUMPS; Pump 1 Configuration Parameters; Pump 2 Configuration Parameters

22
To return to the first horizontal parameter press the button
:
At this point the horizontal menu “General Settings” has been programmed and it is possible to proceed to next menu.
To go back to the horizontal menus press the button
and the “General Settings” menu will be displayed again
Press the button
again to move to the next horizontal menu “Settings Pumps”:
Press the button
to display the underneath vertical parameter:
Press the button again to proceed to the settings relative to Pump 1; otherwise, pressing the button will move to
the next horizontal parameter for the settings of Pump 2:
Following will be described in order of all the settings of Pump 1 (the same independent setting descriptions of Pump 1 are
available for Pump 2).
From the menu “Configuration Pump 1”, pressing the button
will display the following vertical parameter:
11. SETTINGS PUMPS
Sel.Language: X
1=I 2=EN 3=E 4=F
Setting
Password XXXX
Delay Power Ret.
0=RND XXXsec
General
settings
Press Enter to
Set-up Exit
Settings pumps
Settings pumps
General
settings
Operating
Programs
With the vertical parameter “Configuration pump 1” is possible to set all the parameters relative
to pump 1.
Settings pumps
Configuration
Pump1
Configuration
Pump2
Configuration
Pump1
Setting
Password XXXX
The parameter “Setting Password” allows the user to set/modify the password to access the
programming menu.
The “X” indicates the setting of the parameter to modify.
It’s possible to a set a password of 4 digits.
Factory default password is “0000”.