Fourgroup Full-App 2 - 12. OPERATING PROGRAMS; Program DARK Mode Configuration; Program CLEAN Mode Configuration

29
At this point the horizontal menu “Settings Pumps” has been fully programmed and you can proceed to the next menu.
To go back to the horizontal menu “Settings Pumps” press the button
.
Press again the button
to move to the next horizontal menu “Operating Programs”:
Press the button
to display the vertical parameter:
The first operating mode is the program DARK (to select a different program mode just press the buttons
and to
move in the horizontal menu of programs).
12. OPERATING PROGRAMS
Operating
Programs
Settings
Pumps
GSM Modem
Setting
Inside the menu “Program DARK” is possible to activate/deactivate the operating mode “Dark”
for the pumps (this operating mode will apply to all the pumps connected). The program Dark is
particularly suitable for systems managing waste water (this program mode can also be used
for clean water system). Especially suitable for a system using float switches, the program Dark
can be used also with generic dry contacts. The main characteristic of operation of the program
Dark is that the pumps start is controlled via a start float switch and its operation will continue
even after the “start switch” deactivation. The stopping of the pump is controlled by the
activation of its stop float switch.
In this part of the of control panel setting it’s possible to choose the program operating mode
for the pumps. Four program operating modes are available:
- Program DARK
- Program CLEAN
- Program DIGIT
- Program MULTITANK.
Operating
Programs
Program
DARK
Program
CLEAN
Program
MULTITANK
Program
DIGIT
Inside the menu “Program CLEAN” is possible to activate/deactivate the operating mode “Clean”
for the pumps (this operating mode will apply to all the pumps connected). The program Clean
is particularly suitable for systems managing clean water (this program mode can also be used
for waste water system). Especially suitable for system using either pressure switches or float
switches, the program Clean can be used also with generic dry contacts. With the program
Clean the starting and stopping of the pumps are controlled via the start float switch; it is
possible to connect to a minimum level float switch as additional protection against dry running
operation.
Program
DARK
Program
CLEAN
Settings
Pumps
General
Settings
Operating
Programs