3
28
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port.
This item is used to assign the I/O address and interrupt request (IRQ) for the IRDA port.
This item enables you to determine the infrared function of the onboard infrared chip.
This item is used to assign the I/O address for the onboard parallel port.
This item is used to set parallel port mode.
This item is used to assign interrupt request (IRQ) for the onboard parallel port.
This item is used to enable the support for USB devices on legacy OS. If you have a USB
keyboard or mouse, set to auto or enabled.
This item is used to enable or disable the Universal Host Controller Interface for USB.
This item is used to enable or disable the Enhanced Host Controller Interface for USB.
If USB devices are connected to the computer, the following item will appear :
After pressing <Enter>, you can set the reset delay for the USB storage device. There are manyThere are many
selected.
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
Help Item
Module Version - 2.24.1-13.4 Enables support for
legacy USB. AUTOAUTO
USB Devices Enabled :USB Devices Enabled : option disables
1 Drive legacy support if
no USB devices are
connected.
USB 2.0 ControllerUSB 2.0 Controller
F9:Optimized Defaults
To Next Page
Loading...
