Foxconn FlamingBlade GTI - NVIDIA SLI TM Technology

Appendix
113
NVIDIA
®
SLI
TM
Technology
(Only for Flaming Blade)
1. Introduction
NVIDIA
®
SLI
TM
(Scalable Link Interface) technology takes advantage of the increased bandwidth
of the PCI Express
TM
bus architecture, and features intelligent hardware and software solutions to
deliver earth-shattering PC performance in a multi NVIDIA
®
GPU solution.
2. Graphics card conguration
2-1 Installing dual SLI-ready graphics cards
1. Install one graphics card into the PCI-E1_16X slot, the other into the PCI-E2_16X slot.
2. Align and rmly insert the 2-way SLI bridge onto the edge connector of each graphics
card. Make sure that the bridge is rmly in place.
■ In 2-way SLI mode, it needs two identical SLI-ready graphics cards.
■ Make sure that all the graphics cards are certied by NVIDIA, different type of
graphics cards will not work together properly.
■ Make sure that your power supply unit can provide at least the minimum power
required by your system.
■ For the detailed Graphics Card support list on this motherboard, please visit the
website: http://www.foxconnchannel.com
C
A
U
T
I
O
N
!
113