The Effects
52
XFADE TIME - Sets the crossfade time between reverse audio snippets. When the playback
position approaches the delay time a new snippet begins playback at time zero. The crossfade time
controls how long it takes for the old snippet to fade out and the new one to fade in. You can achieve
interesting and rhythmic variations by setting a long crossfade time. For classic reverse delay
sounds set this at or near its minimum value.
LOCUT FREQ - Sets the cutoff frequency of the lowcut filter. Higher values remove more low
frequency content from the delayed signal.
HICUT FREQ - Sets the cutoff frequency of the highcut filter. Lower values remove more high
frequency content from the delayed signal.
Modulation
The
MOD
page contains the various dynamic parameters that can be adjusted. This page also contain
the delay ducking controls. The ducker reduces the volume of the delayed signal when the input
signal is above the ducking threshold. Using the ducker helps keep the delays from cluttering the
sound and helps them ring out when you stop playing.
LFO1/2 TYPE -
Sets the type of LFO for the delay time modulators.
LFO1/2 TARGET -
Sets which delay line(s) the LFO will modulate. You can select to modulate left,
right or both.
LFO1/2 RATE -
Sets the rate of the time modulators. The delay time can be modulated so as to
simulate a worn capstan or belt or to add a chorus effect to the echoes.
LFO1/2 DEPTH -
Sets the depth of the time modulators. Use in conjunction with the rate controls.
DEPTH RANGE -
The modulators use “auto depth”, faster rates automatically decrease the depth
and vice-versa. The
DEPTH RANGE control allows selecting the amount of maximum depth.
DUCKER ATTEN -
Sets the attenuation depth of the ducker. A setting of 20 dB, for example, will
decrease the echoes by 20 dB when the input level is above the threshold. Set to 0.0 to defeat the
ducker.
DUCKER THRSHLD -
Sets the trigger threshold of the ducker. If the input signal exceeds this value
the delayed signal will be attenuated by an amount equal to that set with the
ATTENUATION control.
DUCKER REL TIME -
Sets the rate at which the ducker releases the attenuation when the input
signal falls below the threshold.
DIFFUSION -
Sets the amount of echo diffusion. This causes the echoes to get “fuzzy” and can be
used to smooth the echoes
DIFF TIME -
Sets the delay time for the diffuser.
PHASE REV -
When set to
ON
, inverts the phase of the right channel. This can be used to widen the
stereo effect.
To Next Page
Loading...
