Fractal Axe-Fx - Megatap Delay (Ultra Only)

The Effects
59
FEEDBACK - Sets the feedback level from the last repeat to the input of the delay line. You can
use this in conjunction with the decay to control the overall decay behavior. If you set decay to zero
and feedback to a moderate value, the pattern will repeat getting quieter each time through.
QUANTIZE - Quantizes the tap times to the entered note value. This can be used to aid in tapping
in a rhythm. The tap times will be rounded to the nearest multiple of the note duration. You can
change this value even after you’ve tapped in your rhythm.
LEARN - Sets this to <TAP ENTER> to enter the rhythm pattern learn mode. You can then tap the
desired rhythm in with the
ENTER button. When finished set to <DONE> . If the ENTER button is
not pressed after several seconds the unit will automatically terminate the learn mode.
TAPn TIME - Sets the time of the tap relative to the previous tap. If Quantize is set this will read
out in multiples of the note duration. For example, if Quantize is set to 1/16th, this controls the delay
time between the previous tap and the selected tap in multiples of a sixteenth note.
Diffusor (Ultra Only)
The Diffusor is comprised of four two-second diffusers in series. A diffuser smears transients and
can be used as a type of reverb for creating interesting ambience effects.
Parameters
MASTER TIME - Scales all the delay times. Attach a controller to this for real-time control of the
delay times.
MASTER FEEDBACK - Scales all the feedback amounts. You can attach a controller to this.
TIME n - Sets the delay time each diffuser.
TEMPO n - Locks the time to the global tempo. For example, if the global tempo is 120 bpm and
the tempo is set to a quarter note (1/4) then the time will be 500 ms (one echo per beat). To ignore
the global tempo set the tempo control to
NONE .
FEEDBACK n - Sets the feedback level for each diffuser. For maximum diffusion set to 100%.
MegaTap Delay (Ultra Only)
The Axe-Fx Ultra MegaTap Delay is a 2.5 second, 40-tap delay line with parametric control of time,
amplitude, and panning. This effect can be used to create interesting delay patterns or as a “density
increaser” for use before reverberant effects.
Parameters
INPUT GAIN - Sets the input level to the effect. Attach this to an expression pedal or controller to
produce swell effects.
MASTER LEVEL - Controls the overall level of all the delay taps.
TIME - Sets the delay time of the last tap. The echoes will be distributed between zero and this time.