Fractal Axe-Fx - Synth (Ultra Only)

The Effects
83
VOICE n SCALE - Selects the custom Global Scale to use. See the Global section for more details
on Global Scales.
Auto Pitch (Ultra Only)
The Auto Pitch mode corrects the pitch of the input. This can be used to correct vocal performances
or as a special effect.
All parameters for the Auto Pitch mode are described under the Intelligent Harmony mode.
Synth (Ultra Only)
The Axe-Fx Ultra contains two dual-voice monophonic synthesizers. These are classic oscillator-
based synthesizers and can be used to do synth leads with your guitar or other instrument input.
Alternatively the can be controlled manually.
Parameters
Each synth has two voices with the following parameters:
TYPE - Selects the type of waveform. Sine and triangle are the smoothest while the square and ramp
types are more “buzzy”.
TRACK - Selects the type of input tracking. OFF allows the frequency and level to be set manually
via the
FREQ and LEVEL controls. ENV ONLY selects the level to be controlled by the envelope of
the input with the frequency set manually.
PITCH+ENV selects the frequency and level to be
controlled by the pitch and envelope of the input.
FREQ - If input tracking is set to OFF or ENV ONLY this parameter sets the oscillator frequency.
SHIFT - Shifts the frequency of the oscillator up or down in semitone steps.
TUNE - Detunes the oscillator slightly. The oscillator can be detuned +/- 50 cents.
DUTY - When using the TRIANGLE or SQUARE waveforms this parameter controls the duty cycle
of the waveform.
LEVEL - Controls the output level of the oscillator.
PAN - Controls the panning of the oscillator.
FILTER - Sets the cutoff frequency of a low-pass filter after the oscillator.
Q- Sets the Q of the post-oscillator filter.
ATTACK - Sets the attack time of the envelope follower on the input.