The Effects
78
VOICEn LEVEL - Sets the volume level of the voice.
VOICEn PAN - Sets the panning of the voice.
VOICEn DELAY - Sets the delay time of the voice.
Fixed Harmony
The Fixed Harmony mode creates two voices that are fixed intervals from the input.
MASTER PITCH - Multiplies the pitch shift by this amount. For example, if the shift is set to 12
semitones and the Master Pitch is 50%, the shift amount will be six semitiones.
MASTER DELAY - Multiplies the delay values by this amount.
MASTER FEEDBACK - Multiplies the feedback values by this amount.
MASTER PAN - Multiplies the pan values by this amount.
MASTER LEVEL - Multiplies the level values by this amount.
VOICE1,2 DETUNE - Sets the detune amount of the voice in cents. The range is +/- 50 cents. You
can attach a controller to the detunes by pressing enter.
VOICE1,2 SHIFT - Sets the shift amount of the voice in half-steps. The range of shift is +/- 12 half-
steps.
VOICE1,2 LEVEL - Sets the volume level of the voice.
VOICE1,2 PAN - Sets the panning of the voice.
VOICE1,2 DELAY - Sets the delay time of the voice as a function of the tempo.
VOICE1,2 DLYTEMPO - Locks the delay time to the global tempo. For example, if the global
tempo is 120 bpm and the tempo is set to a quarter note (1/4) then the delay time will be 500 ms.
To ignore the global tempo set the tempo control to
NONE.
VOICE1,2 FEEDBACK - Sets the feedback of the voice to the input. By delaying and feeding a
voice back strange pitch effects can be created as the note is translated pitch again and again.
PITCH TRACK - Setting this to ON instructs the pitch shifter to track the pitch of the input. For
single note work this provides improved results. For chordal work this should be set to
OFF as the
pitch tracker obviously cannot determine the pitch of simultaneous tones.
TRACK ADJUST - This control allows fine-tuning the pitch shifter “splice length”. Higher values
increase latency but may improve sound quality of the shifted note, especially as the shift amount
increases.
To Next Page
Loading...
