The Effects
56
MASTER PAN - Scales all the pan amounts essentially acting as a spread control. The amount can
go negative allowing for the echoes to switch sides. Attach a controller to this for real-time control
of the pans.
MASTER FEEDBACK - Scales all the feedback amounts. You can attach a controller to this.
MASTER FREQ - Scales all the frequency values. Attach a controller to this to vary all the
frequency values in real-time. This can be used to achieve a wah-like effect on the echoes.
MASTER Q - Scales all the Q values. Attach a controller to this to vary all the Q values in real-time.
MASTER RATE - Scales all the LFO rates. Attach a controller to this to vary all the LFO rates in
real-time.
MASTER DEPTH - Scales all the LFO depths. Attach a controller to this to vary all the LFO depths
in real-time.
MASTER PITCH - Scales all the shift values. Attach a controller to this to vary all the pitch shifts
in real-time.
MASTER DETUNE - Scales all the detune values. Attach a controller to this to scale all the detune
values in real-time. By varying the detune values this way, resonances are broken up and the delay
becomes smoother.
DECAY TIME - Sets the coefficients of the feedback matrix for the Plex types thereby controlling
the amount of time for the echoes to fade. Use caution with the Detune and Shift types as high decay
times can result in instability.
DIFFUSION - Sets the amount of cross-coupling between delay lines. In the Quad-Tap mode this
sets the mix level of the diffuser block (see block diagram). The diffuser can be used to smear
transients for an ambient effect.
DIFF TIME - Sets the delay time of the diffuser for the Quad-Tap mode. Longer times will smear
transients over a longer period.
TIME - Sets the delay time of the tap.
TEMPO - Locks the delay time to the global tempo. For example, if the global tempo is 120 bpm
and the tempo is set to a quarter note (1/4) then the time will be 500 ms (one echo per beat). To
ignore the global tempo set the tempo control to
NONE
.
LEVEL - Sets the volume level of the tap.
FEEDBACK - Sets the amount of delay feedback. This controls how many repeats are heard. The
total of all feedbacks must add up to 100% or less.
PAN - Controls the placement of the echoes in the stereo image. Note that this is different than the
BAL control on the MIX page which controls the balance of the mixed sound. This control only
effects the wet signal.
To Next Page
Loading...
