The Effects
81
VOICE1,2 LEVEL - Sets the volume level of the voice.
VOICE1,2 PAN - Sets the panning of the voice.
VOICE1,2 DELAY - Sets the delay time of the voice in milliseconds.
VOICE1,2 DLYTEMPO - Locks the delay time to the global tempo. For example, if the global
tempo is 120 bpm and the tempo is set to a quarter note (1/4) then the delay time will be 500 ms.
To ignore the global tempo set the tempo control to
NONE.
VOICE1,2 SPLICE - Sets the splice time of the voice in milliseconds.
VOICE1,2 SPLTEMPO - Locks the splice time to the global tempo. For example, if the global
tempo is 120 bpm and the tempo is set to a quarter note (1/4) then the time will be 500 ms (one echo
per beat). To ignore the global tempo set the tempo control to
NONE.
VOICE1,2 FEEDBACK - Sets the feedback of the voice to the input. By delaying and feeding a
voice back strange pitch effects can be created as the note is translated pitch again and again.
DIRECTION - Sets the “direction” of the splice playback. Try setting to REVERSE for spacey
effects.
FEEDBACK TYPE - Selects the type of feedback. DUAL sends the individual voices back to their
respective delay lines.
BOTH
mixes the voices and sends them back to both delay lines. PING-
PONG
sends each voice to the opposite delay line.
HICUT FREQ - Sets the high-frequency rolloff of the pitched signal using a 12 dB / octave filter.
This can be used to adjust the timbre of the voices.
CROSSFADE - Sets the amount of overlap in the audio snippets. A low setting will make the
echoes more discrete whereas a high setting will tend to smear the echoes.
Advanced Whammy (Ultra Only)
The Advanced Whammy mode is identical to the Classic Whammy mode except that the start and
stop shift amounts are controllable in semitone increments. This allows you to set the heel down to
any amount of shift and the toe down to any amount of shift rather than being constrained to pre-
programmed intervals.
Parameters
The parameters for the Advanced Whammy are the same as the Classic with the following
differences:
START -
Sets the start pitch shift amount in semitones. This is the amount of pitch shift when the
CTRL knob is in the minimum position.
STOP -
Sets the stop pitch shift amount in semitones. This is the amount of pitch shift when the
CTRL knob is in the maximum position.
To Next Page
Loading...
