The Effects
87
The Send block has no parameters, while the Return block has a basic mixer. Adjust the MIX control
to set the ratio of direct and feedback signals.
Best results are achieved when feeding back a pure delayed signal. If any direct signal is fed back
the resulting loop will usually be unstable and/or sound strange due to phase cancellation.
Warning: Use caution with the Feedback blocks as you can easily program an unstable loop and cause
internal clipping of the signal and/or very high sound levels which can damage your hearing. Always
start with the
MIX
control on zero and slowly bring it up. If you start to hear squealing or other signs of
instability return the
MIX
control to zero and analyze your routing for possible causes of instability.
To Next Page
Loading...
