Controllers and Modifiers
93
The damping control is also effective when using an expression pedal to control a parameter. It can
help smooth out the pedals response, especially if the pedal’s potentiometer has gotten “scratchy”.
AUTO ENG - When set to
ON
, automatically engages the target effect block when activity occurs
on the connected controller. This can be used, for example, to engage a Wah just by moving an
expression pedal.
PC RST - Reset on Program Change. When set to
ON
the controlled parameter will be reset to the
value stored with the preset upon loading the preset. The controller will not control the parameter
until it has changed from its previous value. The value stored with the preset is always displayed in
the value box.
For example, if you want to control the Volume of the Volume block using an expression pedal but
want it to be initialized to 10.0 on preset change regardless of the postion of your pedal set
PC RST
to
ON
. Then set the Volume parameter to 10.0. When the preset is recalled the Volume will be at
10.0. If you move the expression pedal the modifier will then be active and be in control of the
Volume parameter from that point on.
Detaching a Controller
To detach a controller set the source to NONE and press
EXIT
.
To Next Page
Loading...
