39
M.FACSW90IU-00 ITA-ENG 13/03/2023
FD
EN
24.3 Unpacking
When unpacking the unit pay attention not to damage the unit.
The package is made up by different materials: wood, paper, nylon etc.
It’s a good rule to keep them separately and deliver to the proper collecting centre in order to reduce their environmental
impact.
24.4 Positioning
It is necessary keep in account the following points in order to choose the most suitable place for the installation:
- Arrange the machine with the purpouse of allow a adequate air flw(no narrow space);
- Ensure the proximity to the electrical supply;
- Guarantee the accessibility for the service, maintenance and reparation of the unit and its components;
- Ensure that the floor can maintain the weight of the machine;
- Ensure that the space could avoid any side effects due to the noise;
- Maintenance;
Warning: This machine has been designed in order to be installad inside. Before to installed outside contact the
producer.
Warning: The installation place must be choose in order to avoid water flowing to the machine.
Warning: This machine can not be installed in laundry.
Warning: This machine have not to be installed in place with easy access by the pubblic.
25 Installation
25.1 Clearences
Absolute care must be taken to ensure adequate air volume to the air intake and fan discharge, and to avoid air
recirculation through the unit that will deeply reduce its performances.For these reasons it is necessary to observe the
following clearances (see the following pictures):
Mod.
A
Suction Side
B
Electric board side
C
Supply Side
D E
FACSW90 500 200 800 200 200
To Next Page
Loading...
