How to turn on dispenser lanes on Franke F3D3P?
If you're unable to switch on the dispenser lanes on your Franke Dispenser, check these: * Make sure the unit has line power by switching on the power switch. * Ensure you press the ON/OFF button for a full 4 seconds until the button LEDs light up.
Why are the loading weights incorrect on my Franke F3D3P Dispenser?
If the loading weights on your Franke Dispenser are consistently incorrect, check the following: * Ensure the deflector is present in the hopper. If it's missing, slide it in. * Inspect the deflector for any damage, such as cracks. If damaged, replace it. * Verify that the freezer bottom is correctly positioned. If not, take it out and reinsert it properly.
Why won't the drum turn on my Franke F3D3P?
If the drum on your Franke Dispenser isn't turning, it could be due to: * An empty hopper. If the screen displays the error message Err04 and the Action–3 [Reset] button is flashing, fill the hopper with fries and press [Reset] to begin the filling process. * Fries baked together forming a "bridge" in the hopper. If the screen displays the error message Err04 and the ACTION–3 [Reset] button is flashing, shake the hopper to redistribute the fries and break up the bridge. Proceed carefully so as not to break the fries, then press [Reset] to start the filling process.
What does low product warning mean on Franke Dispenser?
If you see the [Low product warning] error message on your Franke Dispenser, it means: * The hopper has a low filling level (only 3–4 fillings left). Refill the hopper with fries. Be aware that if the machine dispenses until the hopper is completely empty, the filling process will be aborted, and error message Err04 will appear. * Frozen fries have created a hollow space around the sensor in the hopper. Shake the hopper to redistribute the fries and close the hollow space, being careful not to break the fries.
Why is the reset button flashing on my Franke F3D3P?
If the ACTION-3 [Reset] button on your Franke Dispenser is flashing, it indicates: * The filling process was prematurely aborted. Press the [Reset] button to restart the filling process. * Fries in the hopper have formed a "bridge." Shake the hopper to redistribute the fries, carefully breaking up any clumps.
What to do if Franke F3D3P shows Err04 and won't dispense?
If your Franke Dispenser isn't dispensing and shows error message Err04, it means: * The hopper is empty. You should fill the hopper with fries and press the [Reset] button to begin the filling process. * Fries are baked together in the hopper forming a hard "bridge". You should shake the hopper to redistribute the fries and break up the clumps, carefully so as not to break the fries. If necessary, remove very hard clumps, then press [Reset] to start the filling process.
Why is my Franke F3D3P Dispenser freezer not cold enough?
If your Franke Dispenser freezer is running but not reaching the required temperature of -18°C, consider the following: * Check for ice formation on the inside walls, especially on the temperature sensor. If there's ice, remove all items from the appliance and defrost it. To prevent ice buildup, avoid leaving the freezer door open longer than necessary and defrost daily. * Inspect the filter for soiling and clean it if necessary. * Examine the condenser ribs for soiling and clean them if needed.
General| Model | F3D3P |
|---|---|
| Brand | Franke |
| Material | Stainless Steel |
| Capacity | 3 liters |
| Installation | Countertop |
| Voltage | 220-240 V |
| Power Supply | Electric |
| Type | Dispenser |
To Next Page
