FRC TankVisionPro WLA300 - Figure 6. Maxvision LED Display Mounting Dimensions

WLA300 Rev170606
18
Figure 6. MaxVision LED Display Mounting Dimensions
14 3/8"
13 1/4"
11 1/2"
5 3/4"
5 3/4"
6 5/8"
6 5/8"
7/8"
7/8"
7/8"
1 7/8"
Front
View
Side
View
Rear
View
Three locations are
available for the wires to
exit the rubber gasket.
Drain
Notch
Mounting holes are
clearance or tapped
for #10 screws.
Calibration
Point
(behind "R")
Photo
Sensor
Note: Do not use Loctite on any screws near the Lexan lens.
Lexan lenses can become brittle and prone to cracking when
exposed to Loctite compounds.