WLA300 Rev170606
19
Install Remote Light Driver
The remote light driver is water proof to allow for exibility in the mounting location.
1. Measure and mark mounting location for light driver. Make sure there is clearance
for driver and cable before drilling holes. Refer to Figure 5 for dimensions.
2. Drill and tap two 10-32 holes.
3. Secure remote light driver with two screws.
4. Connect cable and wires. (Refer to Wiring section.)
Figure 7. Remote Light Driver
2 3/4"
1 3/8"
3 1/2"
4"
1"
Install Buzzer
Install the buzzer close to the TankVisionPro so the audible warning is easily
associated with the TankVisionPro. A cutout hole diameter of 1-1/4" is required.
(Refer to the wiring section.)
To Next Page
Loading...