Configuration of the Freecom Network Drive
Enter your new administrator password and repeat entry in the second field for verifica-
tion. Click on “OK” to apply your new password.
Configuring the time settings
You can setup date and time of your Freecom Network Drive either manually or auto-
matically.
Manual Configuration
Enter date and time and select the “Disable” button in the “SNTP” section to disable the
usage of a time server.
Select your “Time Zone” and choose whether to use “Daylight Saving Time” or not.
Click on “Apply” to save your settings.
Automatic Configuration
Select the “Auto” button in the SNTP” section to enable using a time server for your
time settings.
In the “Time Server” section, you can either select a time server from the pull-down list
or you can use a time server that is not listed in the pull-down list by manually adding
the NTP address in the field below the pull-down list.
Select your “Time Zone” and choose whether to use “Daylight Saving Time” or not.
Click on “Apply” to save your settings.
To Next Page
Loading...
