Freecom Network Drive User Manual

8
Freecom Network Drive
EN
1
1.1 LED Description
SYSTEM: SYSTEM LED is on when the system is ready
LINK: LINK LED is on when a LAN connection is available
Capacity LED: The Capacity LED is a power and activity display. The LED is always
on when the drive is powered and flickers during drive activity.
1.2 Power switch
Please turn the Freecom Network Drive off when it is not in use. This conserves electric-
ity and extends the life of the hard drive. The power switch is located on the rear of the
Freecom Network Drive.
1.3 Reset button
Press the „Reset“ button and power on device while pressing the „Reset“ button. Keep
„Reset“ button pressed for 15 seconds to restore factory defaults.
WARNING! Before turning off the Freecom Network Drive manually, please
make sure to first "unplug or eject hardware". This option is found in the
Windows taskbar. Failure to do so may result in the loss of data.
Capacity LED
SYSTEM / LINK
LAN USB Power Reset on/off

Freecom Network Drive Specifications

Capacity and Interfaces

capacity	250GB, 400GB, 500GB
LAN interface speed	10/100Mbps
USB interface speed	USB 2.0

Hard Drive Specifications

hard drive type	3.5” SATA
average seek time	< 9 ms
track to track seek time	0.8 ms
average latency	4.2 ms
rotational speed	7200 rpm
buffer size	8MB or higher

Data Transfer Rates

LAN data transfer rate	max. 100 Mbit/s
USB data transfer rate	max. 480 Mbit/s

Operating Environment

operating temperature	5º C / 60º C
storage temperature	-20º C / 80º C
mtbf	50000 POH

Weight and Dimensions

weight	1150 gr. / 40.6 ounce
dimensions	21.1 x 11.5 x 3.7 cm / 8.3 x 4.5 x 1.45 inch