Freecom Network Drive User Manual

9
EN
2
Chapter 2: Using the LAN Mode
Note: For initial configuration, always connect your Freecom Network
Drive to a PC first! Do not connect the Freecom Network Drive to an exist-
ing network when using it for the first time!
2.1 Check TCP/IP Settings in Windows 2000/XP
1. Open “Start” -> “Settings” -> “Control Panel”.
2. Double-click on “Network Connections”.
3. Right-click on your “Local Area Connection” and select “Properties”.
4. The following screen will appear. Select “Internet Protocol (TCP/IP)” and click on
the “Properties” button.
Using the LAN Mode

Freecom Network Drive Specifications

Capacity and Interfaces

capacity	250GB, 400GB, 500GB
LAN interface speed	10/100Mbps
USB interface speed	USB 2.0

Hard Drive Specifications

hard drive type	3.5” SATA
average seek time	< 9 ms
track to track seek time	0.8 ms
average latency	4.2 ms
rotational speed	7200 rpm
buffer size	8MB or higher

Data Transfer Rates

LAN data transfer rate	max. 100 Mbit/s
USB data transfer rate	max. 480 Mbit/s

Operating Environment

operating temperature	5º C / 60º C
storage temperature	-20º C / 80º C
mtbf	50000 POH

Weight and Dimensions

weight	1150 gr. / 40.6 ounce
dimensions	21.1 x 11.5 x 3.7 cm / 8.3 x 4.5 x 1.45 inch