Why Freund Industrial Electrical stun effect does not last long enough?
The stun effect may not last long enough due to several reasons. The electrodes might be worn, requiring regular replacement. Also, soiled electrodes can reduce effectiveness, so clean them thoroughly after each stun process. Finally, the stun current might be too low; in this case, check the stun current and stunning parameters.
What to do if Freund STUN-E512 Industrial Electrical shows yellow lamp lights up continuously (stun error)?
If the yellow lamp lights up continuously, indicating a stun error, it might be because the stun current was not reached within four seconds. In this case, repeat the stun process. The yellow lamp should automatically go out during the next stun process, and an acoustic error message will be issued. If the stun process was interrupted within the first 4 seconds, no action is specified.
Why Freund STUN-E512 Industrial Electrical has bone fractures?
Bone fractures can occur due to several reasons: 1. The animal's body may not be fully in the restrainer. Ensure all of the animal’s body is within the restrainer. 2. The animal’s weight might be insufficiently balanced. Check whether the animal’s weight can be supported by non-conductive straps, belts, or the side walls, ensuring none of the animal’s weight is carried by its feet, and the body is relieved. 3. The animal may have been stunned twice. Send the animal to blood draining immediately after stunning, as stunning twice can lead to bone fractures.
What to do if Freund STUN-E512 stun process is interrupted?
If the stun process is interrupted, it could be due to the minimum stun time being interrupted, so repeat the stun process. Also, slow repositioning of the stun tong in head & heart stunning is suggested.
Why Freund STUN-E512 Industrial Electrical has uncontrolled blood spurting?
Uncontrolled blood spurting may occur if the animal was drained of blood too late. To prevent this, perform the blood drain cut within 10 seconds of stunning.
What to do if Freund Industrial Electrical LED display does not illuminate?
If the LED display does not illuminate, it could be due to several reasons: * No mains voltage. Check the mains supply line for interruptions. * A triggered fuse. Replace the fuse. * The thermal contact in the transformer has triggered (overheating protection). Switch off the stunning device and wait until the transformer has cooled off.
How to fix unreadable LED display on Freund STUN-E512?
If the LED display is unreadable, it indicates that the programming is incorrect. Contact the manufacturer for assistance. Please refer to the company information in the imprint for the address and telephone numbers.
Operator's duties for ensuring safe operation, training, supervision, and workplace compliance.
Discusses inadmissible uses of the stunner and strategies for minimizing residual risks.
Instructions for mounting, connecting, and installing safety features for the stunning device.
Safety rules, required PPE, and emphasis on humane treatment of animals during the stunning process.
Step-by-step guide for powering on, selecting programs, and activating the stunning sequence.
Details the procedure for head stunning, electrode placement, and post-stunning blood draining.
Explains the two-step process for head and heart stunning using stun tongs for pigs and sheep.
Describes the procedure for stunning sheep using the H2B handpiece and correct electrode positioning.
Provides a table of common faults, their causes, and recommended remedies for the electric stunner.
General| Brand | Freund |
|---|---|
| Model | STUN-E512 |
| Category | Industrial Electrical |
| Language | English |
To Next Page