5.
Press - the ‘on-air’ LED will flash three times
to confirm the setting has been accepted. If the light
does not flash, wait five seconds and re-enter the
programming sequence from the beginning.
TESTING THE KEYPAD
1. Put the system into Operating Mode by pressing
and holding the button on the Remote
Control for approximately 6 seconds until the
Solar Siren acknowledges the signal by emitting
one long Beep (unless Beep Disable has been set).
2. Arm the system in Instant mode by entering the
User Access Code followed by the ‘INSTANT-
ARM’ button on the Keypad.
,
The Siren will acknowledge the signal by beeping
once.
3. Disarm the system entering the User Access Code
followed by the ‘DISARM’ button on the Keypad.
,
The Siren will acknowledge the signal by beeping
twice.
4. Arm the system in Delay mode by entering the
User Access Code followed by either ‘DELAY-
ARM’ buttons on the Keypad.
, or
The Siren will acknowledge the signal by beeping
once and then again after the 15s entry delay.
5. Disarm the system entering the User Access Code
followed by the ‘DISARM’ button on the Keypad.
,
The Siren will acknowledge the signal by beeping
twice.
6. Activate the Personal Attack (PA) alarm by
pressing and holding both ‘Delay-Arm’ buttons on
the Keypad and .
After approximately 2 seconds a Full Alarm
condition will be initiated.
7. Immediately Disarm the system entering the User
Access Code followed by the ‘DISARM’ button on
the Keypad.
,
The Siren will stop sounding.
8. When you have finished testing the Keypad, return
the system to Service Mode by pressing and
holding the button on the Remote Control
for approximately 6 seconds until the Siren
acknowledges the signal by emitting one long
beep (unless Beep Disable has been set).
PASSIVE INFRA RED (PIR)
MOVEMENT DETECTORS
PIR Detectors are designed to detect movement in a
protected area by detecting changes in infra-red
radiation levels caused for example when a person
moves within or across the devices field of vision. If
movement is detected an alarm signal will be
generated, (if the system is armed). PIR Detectors will
also detect animals, so ensure that pets are not
permitted access to areas fitted with Passive Infra Red
Movement Detectors when the system is armed.
The detector incorporates a tamper protection feature
to protect against attempts to interfere with the
device. If the battery cover is removed, an alarm will
immediately occur at any time.
The detector also incorporates a sensitivity adjustment
feature to compensate for situations where the
detector may be affected by environmental changes,
(e.g. insects, air temperature, etc.).
To conserve power and maximise battery life the PIR
detector will only detect movement if there has been
no movement detected within the previous 2 minutes.
The PIR Detector is powered by a PP3 Alkaline
battery which under normal conditions will have an
expected life in excess of 1 year. When the battery
level drops, with the PIR in normal operation mode
and the battery cover fitted, the LED behind the
detection window will flash. When this occurs the
battery should be replaced as soon as possible.
(Note: in normal operation with the LED behind the
lens will not flash on detection of movement).
Any number of PIR Movement Detectors can be used
with your system, providing they are all coded with the
system House Code and are mounted within effective
radio range of the Solar Siren.
To Next Page
