In order to correct any initial programming errors,
during the execution of the GR2 cycle it is always
possible to vary the time setting via the following
procedure:
- With the cycle in progress, press the SLUSH key
once. (fig. 1)
- The LEDs of the UP, Confirm and DOWN keys
light up and the GR2 message relative to the cycle
in progress is viewed on the display. (fig. 2-3)
- Press the SLUSH key again.
- The numbers relative to the previously configured
time setting appear on the display: press the UP
and DOWN keys to correct the value.
- Press the CONFIRM key to validate the new data
and exit programming. (fig. 4)
Fig.1
Fig.2
Fig.3
Fig.4
To Next Page