We suggest using the following sanitising
solution:
Ecolab P3 Topax-san
(4% dilution = 200 ml every 5 litres of water).
• Pour the maximum admitted load of cold drinking
water into the machine to rinse the surfaces which
were just treated with the sanitiser.
• Drain the rinse water and turn the machine off.
• When pre-washing is over, all the removable parts in
contact with the product must be disassembled and
sanitised in a separate tub.
SANITISING REMOVABLE PARTS
PREPARATION OF WASHING TUB
• Wash your hands well and/or wear disposable
gloves.
• Fill a clean tub with a sufficient amount of drinking
water at approximately 50°C and the sanitizer.
• Prepare the supplied brush and the OR disassembly
device and immerse them in the solution.
REMOVING AND CLEANING THE DOOR (T4S)
• Lift the blocking lever and open the door by rotating it
to the left.
• Pull the hinge pin upwards and remove the door,
holding it with both hands.
•
Handle the door with great care: because of its great
weight, should it fall, it could cause injuries to staff and
damages to things.
• Rest the door on a clean work surface and
disassemble its parts:
1. Remove the plastic lid from the hopper.
2. Unscrew and remove the plastic knob.
To Next Page
Loading...
