RINSING AND DRYING
• Wash your hands well and/or wear disposable latex
gloves.
• Remove from the sanitising tank all the components
which were previously disassembled, brushed and
immersed.
• Rinse them with plenty of cold drinking water, making
sure to remove all possible leftover sanitising solution.
• Place the rinsed components on a clean table and let
them dry in the air.
DO NOT use rags, sponges or anything else to dry the
components. Make sure no dust or other impurities
come into contact with the sanitised surfaces while
they are drying.
• Also carefully rinse the fixed parts of the machine
which were treated with the sanitising solution
(cylinder, bib, etc.)
• When all the components are dry, put them back onto
the machine making sure the gaskets and scrapers
are in good conditions.
To Next Page
Loading...
