Fritz! 6000 - Page 77

Problem Poss. Cause Solution
“LAN bridge”
mode enabled
(LED flashing or-
ange, repeater
was previously
connected via LAN
cable).
Restore the factory settings to
the repeater; see page72.
Keylock of the
FRITZ!Box en-
abled.
Disable the keylock in the user
interface of the FRITZ!Box
(http://fritz.box) under “Sys-
tem / Buttons and LEDs”.
The MAC address
filter of the FRITZ!
Box is enabled.
Enable the “Allow all new
wireless devices” setting in
the FRITZ!Box.
This setting is located under
“Wi-Fi / Security” or “Wi-Fi /
Wi-Fi Network” in the user in-
terface (http://fritz.box). The
Advanced view must be en-
abled in the user interface.
No Wi-Fi connec-
tion to the FRITZ!
Box can be estab-
lished.
WPS is switched
off in the FRITZ!
Box.
Enable the setting “WPS
enabled” in the FRITZ!Box.
You can find the settings in the
user interface (http://fritz.box)
under “Wi-Fi / Security / WPS
Quick Connection”.
LED is off and
LED flashing
orange. No Wi-Fi
connection to the
FRITZ!Box can be
established.
“LAN bridge”
mode enabled (re-
peater was previ-
ously connected
via LAN cable)
Restore the factory settings to
the repeater; see page72.
FRITZ!Repeater 6000 77
Malfunctions
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •