Fritz! 6000 - Page 78

Problem Poss. Cause Solution
WPS function is
switched off in the
wireless router.
Enable WPS in the wireless
router. See the documentation
of the router for instructions.
The MAC address
filter of the wire-
less router is en-
abled.
Disable the wireless router’s
MAC address filter. Instruc-
tions are provided by the man-
ufacturer, for instance, in the
device manual.
After establishing the Wi-Fi
connection you can disable the
MAC address filter again.
Unsuitable Wi-Fi
encryption config-
ured in the wire-
less router.
Enable the encryption method
WPA3 or WPA2 (CCMP) in the
wireless router. Instructions
are provided by the manufac-
turer, for instance, in the de-
vice manual.
A Wi-Fi connection
to another wire-
less router cannot
be established.
“LAN bridge”
mode enabled
(LED flashing or-
ange, repeater
was previously
connected via LAN
cable).
Restore the factory settings to
the repeater; see page72.
FRITZ!Repeater 6000 78
Malfunctions
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •