Froling TX 150 - Loading Wood Chips in a Partially Emptied Store; Loading Wood Chips in an Empty Store

Operating the system
Filling/ refilling the store with fuel
Page 22
B 067 03 11_en v
3
Permitted fuels
Caution:
Depending on the fuel and the fill level, different procedures must be
followed for filling the fuel store.
3.2.1 Loading wood chips in a partially emptied store
If there is still sufficient fuel in the store (the head of the stirrer is
completely covered with fuel), the store can be filled:
 Load the fuel at the filling opening
3.2.2 Loading wood chips in an empty store
 CAUTION! If the head of the stirrer is already free of material
and the arms / spring blades are extended, then the feeder
unit must be active during the filling process.
 Press and hold the service program key ( ) for 5 seconds
 “Extra heating” mode is activated
 Load a small quantity of wood chips and wait at least half an hour
(preferably an hour) until the arms / spring blades are touching the
head of the stirrer
 Only then should you load the remaining material